Hood $150.00. Has spot rusted trough where radiator leaked. Driver door $150.00 Passenger door(with Glass) $200.00 Driver fender $200.00 Passenger fender $200.00 Painted front bumper $150.00 Door hinges set $100.00 4-speed transmission (borg Warner) $150.00 5-speed transmission ZF (small block) $400...

Make sure column is grounded through the rag joint.

Tried to add photo but it wouldn’t let me

]This skid is 2600 lbs.
Trailer is about 2-2500 lbs
Probably 6-700 lbs young weight.
I have had 4000 lbs on this trailer with zero issues.
F-250 extra leaves in the rear.
Cummins 4BT Borg Warner 4-speed with Watson O/U/D

Take the starter off and grease the shaft that the bendix is on.
I had to do the some thing on a welding machine a couple of weeks ago.

Thank you

Where did the coat hook go originally?
I just found mine and would like to put it back in the right location.
Thank y’all

I swapped a 4BTA into my 66 F250 and milage is in the low 20’s.
Far better than the 13 mpg with the 300/6. Cummins has a lot more torque as well.
I am very happy with the swap.

NOS wiper motor

difficult with torch without overheating. The easiest way is to find a piece of heavy tubing the spring will fit in. Heat the tube with the spring inside until the spring is no longer magnetic (1450) heat a little higher because material must be at critical temp (1450) when it goes into quench. Almo...

You could try to retemper the ones that have been in the fire.
Heat to non magnetic 1450 quench in oil.
Warm to maybe 400 let cool. If spring is to stiff reheat to a higher temperature and let cool.

My heater switch arcs when I turn it on.
I assume there must be a insulator around the shaft that opens the defroster.
Has anyone tried to disassemble and rebuild one of these cables?

Drum/drum mc will have correct residuals.
Also compartments will be equal.
Getting the correct mc is a easy solution

Reread post.
You need a drum/drum mc

Is your mc a drum/drum or a disc/drum?

I am pretty sure my flywheel was drilled for two different pressure plates.
I think you can use a 10” or 11” clutch

Nice!