I cannot speak on how others ship to Canada but the way we do it is if its up to a certain size ship by U.S. Mail,,, then if its real big then Via Ups make sure they put on the box ANTIQUE AUTO/TRUCK PARTS & should save you some money,, Some companies can take the time & send by U.S.Mail if ...

Here is the correct story on 460's The first year put in a truck is 1973 F-250/350 Trucks, Then 1974 F-100/350 Trucks, Then 1975-1976 F-100 F-150/350 Trucks, then 1977-1979 F-150/350 Trucks,,, No 4x4 trucks with factory 460's but also vans starting to have 460's in them in 1975.... I have been using...

We also sell thre Mono-Leaf Springs, But not here to push them Anyway before you jump into it there is 2 sets of springs,,, One set has the standard eyes which can lower the truck down say 2 inches or with the reverse eyes on the mono-leaf springs from 4-6 inches & this depends on size of powerp...

Here is a ? how come on the drivers side I can see fresh paint up close to the floor by the wheel, that paint should not be there, How come there is no needle for the fuel gauge also painted only areas where he could reach the black paint on the rear end, Cute driveshaft I would be afraid when I san...

I am with William 4500 way to much,,, You missed the cab corners they have cancer also the lower door hinge pillars have had a piece of steel covered over it ,, If this is what we see so far in the cab Whats the rest of truck like To me the cab is trash,, Could not see the front cab mounts either,, ...

Cannot speak for Alaska or Hawaii since they are the only 2 states that have not driven to,, Almost went once with our Big Truck but have been to every lower 48, All Canada Providences & Mexico City hauling loads British Canada is very nice of where we were going to about 150 mile North of Vanco...

On the old site I posted all this info so we will do again for this one 1957-67 axles are the same with the Ford 9" 28 spline & 30" long 1948-66 axles with the spicer rear end 30" long with locking rear end 1968-72 axles with Ford 9" 28 spline & 29 15/16" long 1968-7...

Here is how we installed A Tilt column in a 56 F-100 Still with Straight axle Original Gear Box in which is the same prinicipal as 61-64 boxes,,, Took the original box where the shaft the comes out, cut it down to leave few inches to install what they call Universal Joints or Borg. Joints that they ...

How come we can send a man to the moon or up in the space shuttle but down here cannot figure out how to make a bridge meet the road on the interstates without feeling it Next how come say in Nevada they can build a 20 mile section of 4 lane Hwy. in the matter of months but other states years to do...

Unless you have thick door panels, The proper way for installation of handles is to be 100% sure that your handle goes all the way in past the splines so when the set screw goes down in that ridge when tightening it can not come past the splines, With both of our work trucks nevr had a handle come o...

History Channel is on doing history of Ice Cream & there it went by a 65/66 Good Humor Ice Cream Truck, also a 48/50 Truck also was parked under a shade tree

Roger how far are you from Oslo for the reason there is a guy building a 57/58 F-100 that I have been sending some parts too so your not alone over there with a 57-60 body style truck

Like the previous posts , check compression, Bent Valve, Burnt Valve, Crack in the valve seat, Bent push rod, low compression on a cylinder Try this while running take a spark plug that is loose, hook a wire to it and see if the electrode is firing remember to ground out the plug so you can see it i...

Man that was quick Just goes to show you might can run but cannot hide

This show is nice to see ALL kinds of trucks from pickups to the Semi's... A lot of Chevy stuff But we do go to show them up The Semi's put on a real nite time show If its hot then its like going to the beach The Semi's you will see with tires off polishing there rigs there woman up on latters polis...

What I like to know is everybody still using the same names Since I did not, But want to see how long it takes to figure who I am Maybe I might get on the answer