Page 1 of 1

3 speed Ford manual transmission

Posted: April 30, 2016, 2:51 pm
by shipwrecked
I am going to button up the 3 speed transmission here soon. What type of fluid do I need to fill it with?
I was down at a parts house earlier for the other gas burner and just happen to walk by the gear oil and notice there are a few things that I have never heard of.

GL3,
GL4,
GL5

apparently they all have anti- wear properties.

The machine shop guy I have been working with for the block mentioned that I need to be sure which fluid with GL # for that transmission.

What say the slick 60's guru's?
Image
Image

Re: 3 speed Ford manual transmission

Posted: April 30, 2016, 3:34 pm
by FOUR29SCJ
80w-90

Re: 3 speed Ford manual transmission

Posted: April 30, 2016, 4:52 pm
by SteveCanup
I agree....that's what I used in mine. Drained the old stuff out, replaced with 90 weight gear oil.

Re: 3 speed Ford manual transmission

Posted: April 30, 2016, 7:50 pm
by tomrooster
GL # 5

Re: 3 speed Ford manual transmission

Posted: April 30, 2016, 7:52 pm
by tomrooster
Lets take a look at the API GL-5 rating. It is a rating for EP (Extreme Pressure) protection. The higher
the EP protection, the higher the GL category. In the mid 60's, Ford needed better protection in their
pickup trucks

Re: 3 speed Ford manual transmission

Posted: May 1, 2016, 9:26 pm
by shipwrecked
Well I am annoyed beyond belief at the moment.

I was changing out that snap ring on the speedo gear and noticed the shaft started drifting out and i can't get it to go back to where it is supposed to be. If I tighten the transmission extension piece down, it binds the shaft.
Just struggled with this for about an hour before I walked away.

ImageNoticed a crack in the engine side shaft cover. Not sure if I can repair that with jb weld or if I could even find replacement piece.
Image

This is the piece that is cracked
Image

Re: 3 speed Ford manual transmission

Posted: May 2, 2016, 7:05 am
by bruceandersson
Take your main shaft out and make sure something is not out of place, keeping it from fitting. Measure your cracked part. Someone on here must have a 3 spd they've taken out and would be willing to part. You can't jb weld that part. It could be welded if you pre-heat the part since it is cast.

Re: 3 speed Ford manual transmission

Posted: May 2, 2016, 9:20 pm
by shipwrecked
I called FlashbackF100's but they are out on the road. Said for me to call back Saturday.

This is what I measured.
Image[/URL[URL=http://s1280.photobucket.com/user/CoastieReid/media/Shipwrecked/0220C286-7D3B-4943-AAA5-BC9E4C9B414E_zps7dsuhchv.jpg.html]Image
Image
Image

Re: 3 speed Ford manual transmission

Posted: May 4, 2016, 7:02 pm
by tomrooster
If you want a trans out of 1 65 6cyl come pick it up if you want the cracked piece send me a pm All I want is the cost of shipping. Tom