Door insert profile trim
- unibody madness
- Posts: 2140
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969
Door insert profile trim
Hey guys can anyone tell me if the trim for the door inserts line up to the outside edge with the profile stamped into the doors? In other words is the trim entirely inside the flat of the stamping?
Turk build thread at:
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
Re: Door insert profile trim
I still haven't learned the NEW way to post pics, but most of the holes for the trim is in the flat stamped area, but the actual outside edge of the trim pertrude at least 5/8" outside of the flat area.
The TOP FRONT trim on both doors covers the entire upper (door to hinge bolt) access cover.
Hope this helps some....
The TOP FRONT trim on both doors covers the entire upper (door to hinge bolt) access cover.
Hope this helps some....
- unibody madness
- Posts: 2140
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969
Re: Door insert profile trim
Thanks, thats what I am looking for
Turk build thread at:
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!