'65 F100 Bell Housing? Pivot Point broken

born2 · Post by **born2** » February 14, 2007, 1:42 pm

any experience here? Our pivot point has let go---rewelded...

1)advice?

2)replacement bell housing w/pivot pt attached for sale?

Thanks!!

Steve (706) 799-9292
garnersteve@comcast.net

ICEMAN6166 · Post by **ICEMAN6166** » February 14, 2007, 1:51 pm

6 cylinder or 352?

MattsIASlickShop · Post by **MattsIASlickShop** » February 14, 2007, 8:16 pm

you should be able to unscrew it and put in a new one, I think

needmoretime · Post by **needmoretime** » February 15, 2007, 9:34 pm

I had the bracket bolt (one of two) broke off in the block. It holds the ball on the eng side for the Z bar. I tryed keeping the one tight but had to repair it later on. I could not get a finger on it to get it out so I started pulling the engine. While it was half out I unscrewed it with my finger.

65 352

WK

FORDMANLCRACKEL · Post by **FORDMANLCRACKEL** » February 15, 2007, 9:46 pm

He may be talking about the throwout bearing lever it has a pivot point inside the bellhousing.

Lonnie

Slick Fan · Post by **Slick Fan** » February 16, 2007, 12:05 pm

Sounds like we need more info.