I got stuff done but didn't finish what I wanted to. I guess some progress is better than no progress.
Brakes are finished and operational now. Had to punt with the stainless steel lines as the metal/flaring was just hard to get a sold flare. The good tool made for it had trouble
. Oh well they are done now with steel lines a hell of a lot easier to flare. 
I installed the engine and figured out that it was locked because the transmission was in a bind some how. I pulled the engine and tranny then separated the two. Put them back together and all is now working. They are back in the truck.
I went to install my nice new (looking) drive line and figured out the yoke was keyed and would not install in my tranny
I know I tested it before sending it off to the shop so either I am smoking crack or there was a mix up at the shop. Who knows but I now have to go to the bone yard Saturday for a yoke. Such a joy I tell you. Installed the rear driver's window and found that it would not roll up all the way. so I will have to figure that out but I think I will install the passenger rear window first just to see what happens.
Got the right inner fender, hood hinge and core support bolted in.
Here are a couple of pictures we will see if she makes it to SS4. Starting to think that it might.........................................................
at least it was under warrenty. 
It wan't that bad just a little cut but it sure does help getting some assitance. 
