Slick 60's

I need to replace the end 6" (past the latch piller) of the drive side rocker panel due to crash damage. I have looked at the after market parts and they show the rocker panel to be 37.5" long and the full rocker length on the Uni is closer to 47". Does anyone make the correct rockers for the F100 Unibody? Thanks in advance.

Uncertain of exactly what part you are referring to when you say rocker, but suspect you are talking about the bottom plate in the doorway or as some say the step plate, is this so? I have a pair of NOS step plates from Ford, but not certain these fit your truck. Frankly, I have these stored somewhere and don't exactly know where at the moment. Even so, I would only sell as a pair if these are what you are looking for. I have a lot of parts like this I bought years ago and stored for future use. Since I have no plans to use these, and none of the trucks I have need these I would be willing to part with the pair. If interested , PM me and I will try and find and take pictures and measurements.

Rich

Rich I suspect he is talking about the piece that runs forward and aft under the step.
Just for future possible use what are you asking for the steps if he does not want them?

Rich is correct I need the part under the step. I found another post that discussed after market rockers and it said they were shorter than original. The original was a stamped part and the after market looks to be roll formed.

150 for the pair, but would need to measure to make sure good all the way to front.