I am going to install a Warner T86 in my 64 behind the 292. I have a car T86 and a truck T86. The truck version has a messed up cluster but the car one is AOK. I will put the truck input shaft in the car T86 and have the drive shaft shortened. I also have a later Warner T85 out of a 70s Ford truck. ...

Iceman, I saw your pics when I did a search and they are very helpful. The measurements of the top 2 holes on the bracket should be enough and I sure appreciate it. I do have a left vent pull where your truck has the "dimple" on the dash but it should clear it. Thanks again for the help POP

I need the template for mounting the correct spotlight for my truck. Unity will sell me the complete installation kit which includes the template along with many other components for $80 which is a little steep since all I need is the template. Does any one have the template they could copy and send...

I have repaired my 64 tailgate. Cut out and welded in several pieces across the upper and lower horizontal pieces. Why do these corrode from the inside out? I notice the gap-s on the end uprights and wonder should those gaps be filled with seam sealer to stop some of the water entry into the upper a...

I used only the 1" square tubing. Fastened the tank to it and then fastened the frame to the frame of the truck in the front and rear. In the Mustang, the tank is merely screwed to the floor. No straps.

Just put one on my 292 674F100. Starts much quicker, idles smoother, don't know about mileage yet. I Finally gave up fighting the foreign made crappy points. Have to change over the 312 in my 56 sedan now!!

POP

Thanks for the input guys. I will have to drop the 303 out and do some measuring. Should have everything I need if the input shaft is the right length.

POP

Can anybody identify the 2 I am not sure about: Trans ID----trans pilot---Thrust Brg dia---- input spline---input extension T86-1N-------4.68"------------1.75"-------------1.37" X 10-------7" T85N ---------4.81" -----------1.43"-------------1" x 10-------6.5" ...