Ford five speed question

The place to talk Slicks. All we ask is that discussion has something to do with slicks...

Moderators: Casey 65, Kid

Post Reply
User avatar
blulightman
Posts: 31
Joined: September 28, 2008, 11:19 pm
Location: colorado springs

Ford five speed question

Post by blulightman »

I found an '89 F-150 yesterday with a five speed. Is this the unit made by Mazda? it seemed considerably longer than the t-5.But as well, since it was bolted to a 300 as it sat, I would think it would really simplify my change to a 5 speed. how does that(ford) unit rate against the t-5
'66 sb100 daily driver 300/NP
Mallory Unilite, sway bars front and rear.
refreshing m50D-R2
Thunderboy
Posts: 335
Joined: August 26, 2008, 2:24 pm
Location: Sacramento, California

Post by Thunderboy »

Likely an M5OD-R2, aka M5R2. Integral bellhousing, hydraulic T/O bearing. If from a small block, it would bolt up to your 300. Change out the rubber shift seals, notorious for leaking and ruining the trans. Lots of info about trans on this site and throughout the web. I have one in my 92 F250 4x4 behind a 7.5L with 198K miles, and I like 'em, but some don't.

Drew
User avatar
Johnny Canuck
Posts: 8291
Joined: April 9, 2006, 11:14 pm
Location: Edmonton, Alberta.
Canada

Post by Johnny Canuck »

GregD loves them
FordBoyPete hates them

Think I would have grabbed the whole shootin' match and bolted it up since it was already behind a 300.
T5 is a better tranny but that would just have been too easy.
It's a race.. Will hell freeze over or will JC finish his truck first. Stay tuned..
Bodyworx!
Posts: 90
Joined: January 2, 2008, 3:15 am
Location: Dyer, Indiana

Post by Bodyworx! »

Sorry DOuble POst !! Read Below.
Last edited by Bodyworx! on October 12, 2008, 10:29 pm, edited 1 time in total.
" You can fix anything with Duct tape, Bailing wire and a welder ! "
Bodyworx!
Posts: 90
Joined: January 2, 2008, 3:15 am
Location: Dyer, Indiana

Post by Bodyworx! »

Does anyone have a link to the thread with the differences of these two transmissions? How do you tell em apart at a glance. I have a line on a early 90's F150 with a 300 and another older 150 with a 300 and a 5 speed.

Thanks ahead,

PHIL
" You can fix anything with Duct tape, Bailing wire and a welder ! "
Post Reply