Page 1 of 1

1964 292 Original Engine Block Color?

Posted: July 27, 2009, 1:00 pm
by Californiagold
Hello All -

Well, my Slick & I are off to a bit of a bumpy start...

First there was the fender bender I wrote about on the parts forum - the good news there is that the claim is settled and the truck is looking better than ever!

With the truck looking so good, I decided to have a 'smokes on start-up' issue looked into - I wasn't too worried because the motor had good compression when I checked it prior to purchase - but to make a long story short, it turns out that the block was not properly prepared by the PO prior to rebuild, and it now needs to be replaced. :(

As long as I am going this deep, I'd like to make everything as right as possible, which on this truck means originality - and I am not sure what color the block on this truck is supposed to be. It came to me light blue, but I have heard that yellow may also be the original color - does anyone know for sure?

Thanks in advance - I look forward to resuming life on the road with my Slick shortly.

Best,

Charles Danek

Posted: July 27, 2009, 1:07 pm
by ICEMAN6166
factory was black with ford red valve covers.

Posted: July 27, 2009, 4:26 pm
by oldtrucks
Glad to hear you are keeping on original. Look forward to it being running again

Posted: July 27, 2009, 8:33 pm
by factorystock
This is the right place to ask and you now have the correct info. Many things seem to get altered over time and different owners, but we always will try to answer the questions to the best of our knowledge.

Posted: July 27, 2009, 11:43 pm
by Californiagold
Thanks all - I really appreciate the responses.

I love working on my truck and fixing what I can but a complete engine rebuild is well beyond my expertise - plus there is time to consider - so I wound up getting a turn key rebuilt motor from Bob at Bob's F100.

I talked to him at length about the job he'd done on it, and he really seems to know what is going on with these engines. I did a little research prior to pulling the trigger, and actually came across a few articles he has written about the 292 Y-block.

The motor came to me from Bob painted dark Ford Factory Blue - after hearing responses from the group (and searching through old posts) I have decided to leave it that color since (as Iceman you point out in another thread) it is easier to diagnose any future leaks against than original black. But I will paint the valve covers red, so that at first blush the look of the engine at least honors how it came from the factory.

I should be back on the road in another week or so - I will keep you posted!

~ charlie