Page 1 of 1
How to clean a C6 trans?
Posted: September 5, 2009, 3:13 pm
by Gary Seymour
I want to clean and detail my C6 before it goes in the chassis and put new seals in it, etc....
Anybody know a good way to get the aluminum housing clean? Can / should the trans be painted?
Posted: September 6, 2009, 8:05 am
by Ford4jack
Gary,
There's a cleaner that's used on commerical equipment that works well.
Don't know the name of it but its stout and works great on aluminum.
We used it on construction equipment and it would remove the oxidized paint layer in about 10 minutes.
Might check with a local truck or farm / construction dealer about getting some.
Posted: September 8, 2009, 12:14 am
by Fordman
wash it down with caustic soda. dont let it soak in it. that will get the junk off and make it dull. then there is another mild acid wash that will shine it up. but i cant remember the name of it. it is yellow colored. thats all i can remember about it.
Posted: September 8, 2009, 12:34 am
by dwbr
i used some of that gunk foamy degreaser, then used a pressure washer, was spotless, i made sure i didnt get any of the openings and put the new seals in when i was done, after installed i filled with fliud, ran it for 10 min in park, then drained it all and put new fluid back in,,
________
Honda Freed specifications
Posted: September 8, 2009, 5:09 am
by Gary Seymour
Thanks for the tips!! I think I'll try the Gunk and pressure washer first, since that stuff is readily available. Maybe I'll post some pics!!!
Posted: September 8, 2009, 8:14 pm
by Casey 65
Will it fit in your wifes dishwasher???? Just a thought...
Posted: September 8, 2009, 9:59 pm
by Phil
Ive tried simple green, POR marine clean, Dawn dish soap, gas, and kerosene.
K works well but I swear by Autozone cheap brake clean.
You can degrease a trans with about 6 cans. NOTHING works better
no after shot of this but 2 hours and a few cans of brake clean had it completely degreased. Sweet cross member no?
Posted: September 8, 2009, 11:19 pm
by Fordman
how did you put the yellow OK back on the valve cover? do you have a stamp or did you make a stencil to paint it on with?
Posted: September 9, 2009, 10:35 am
by Obsa
Phil wrote:Ive tried simple green, POR marine clean, Dawn dish soap, gas, and kerosene.
K works well but I swear by Autozone cheap brake clean.
You can degrease a trans with about 6 cans. NOTHING works better
Phil, surely you didn't get from photo 1 to photo 2 with just Autozone cheap brake clean?
Posted: September 9, 2009, 5:39 pm
by LM14
That AutoZone stuff must be great! It changed the air cleaner housing, master cylinder and fixed the rust in the firewall and did some rewiring!
I gotta get me some of that and spray it on my wife!
SPark