Page 1 of 1

I almost messed up!

Posted: February 7, 2007, 2:06 pm
by Bills 66
I went and looked at a '66 Fairlane convertable. It needed a lot of work. I made the decission to put the money into my '65 slick. As the Iceman would say I am building a car.
Aerostar front end, ladder bar rear, 427 C6. I concider it pure hotrod. I have all the major parts to complete, but have a couple of questions before I do any more work.
1) Are there larger brakes that will work on the aerostar front end?
2) Since I am altering both the front and rear frame/suspension will I be better off to build a new frame or graft onto the original.
I am not building a show car or a prostocker, I want to end up with a semi stock appearing truck that will go like the heck. Lightened and lowwered some but not in the weeds.
Anyone have any ideas or suggestions before I formulate a hard plan?
Bill

Posted: February 7, 2007, 2:25 pm
by ICEMAN6166
Bill i cant help with the aerostar info but i think you made a good choice to work on your 427 and truck instead of buying the fairlane.
next time i visit i hope the 427 is not still on the stand.
if you see any f100 4x4s for sale cheap let me know, even a bumpside is ok as the hard parts are the same as the 66.

Posted: February 7, 2007, 2:57 pm
by Greg D
Even aerostar sized disc brakes will be much better than the drum brakes that were likely used to slow that engine down originally. Buy some good rotors (grooved) and some real good pads and you should be fine. You can also do a rear disc conversion for a little more whoa. There are bolt on kits for 9 inch rears out there.

Posted: February 7, 2007, 3:21 pm
by Johnny Canuck
I always figured that unless you have anti-lock brakes, that disc rears were more of a cosmetic thing than practical.

drum brakes will already lock up a typical 1/2 ton well enough to bring the arse end around in an alarming hurry. :shock:

Not sure if there are bigger rotors for Aerostars or not, Bill, probably swap out with something, but I am not aware what that might be.