302 to 351w t5 swap questions
Posted: February 8, 2007, 11:44 am
As some of you may or may not know, My grandson and I recently purchased 66 stepside with a 351w already installed. Unfortunately, the install was done poorly, with a later 4 speed granny tranny. Mostly a butcher job. Cut out the crossmember, butchered floor. etc. Fairly certain the orignal 352 engine stands were used, which led to clutch linkage problems, which offset the z-bar, and caused the throwout arm to be forced sideways. This in turn caused the throwout bearing to ride oddly on the pressure plate causing the fingers to wear out. Clutch plate was in good condition. Flywheel need resurfacing.
Anyway, this has brought me to changing the transmission to something more user freindly, and a little better on gas. My options are a 4 speed overdrive cast iron transmission from a 78-9 Granada, 4 speed aluminum type from 78 Mustang, or van, or a recently acquired T5. I have no bellhousing or flywheel for the T5, but do have the front dust cover. So I'm wondering what options I have. I have the 11 inch clutch setup for the 351w but don't know whether this would work with a T5 bellhousing. I don't have a 28 ounce flywheel for the T5 otherwise, which is obviously of smaller diameter, than the 11 inch I have. Other options include buying an adaptor for the T5, roughly 130$. However, I'm uncertain that this will work with the truck bellhousing I have. Along with these problems, I'm wondering how shifting location on the T5, and shifter length will work out if I use the T5. I do have a set of 2001 bucket seats I can install in the truck, to help in location, but still wondering about a shifter and if it will have to be lengthened to accomidate working in a truck. This will obviously lengthen the throw on the shift.
Questions
1. What flywheel can I use with the t5 bellhousing that is 28 ounce?
2. Will the adapter be user freindly?
3. Will the aluminum 4 speed hold up?
Any suggestions?
Thanks,
Rich
Anyway, this has brought me to changing the transmission to something more user freindly, and a little better on gas. My options are a 4 speed overdrive cast iron transmission from a 78-9 Granada, 4 speed aluminum type from 78 Mustang, or van, or a recently acquired T5. I have no bellhousing or flywheel for the T5, but do have the front dust cover. So I'm wondering what options I have. I have the 11 inch clutch setup for the 351w but don't know whether this would work with a T5 bellhousing. I don't have a 28 ounce flywheel for the T5 otherwise, which is obviously of smaller diameter, than the 11 inch I have. Other options include buying an adaptor for the T5, roughly 130$. However, I'm uncertain that this will work with the truck bellhousing I have. Along with these problems, I'm wondering how shifting location on the T5, and shifter length will work out if I use the T5. I do have a set of 2001 bucket seats I can install in the truck, to help in location, but still wondering about a shifter and if it will have to be lengthened to accomidate working in a truck. This will obviously lengthen the throw on the shift.
Questions
1. What flywheel can I use with the t5 bellhousing that is 28 ounce?
2. Will the adapter be user freindly?
3. Will the aluminum 4 speed hold up?
Any suggestions?
Thanks,
Rich