Page 1 of 1
240/300 valve covers and plates
Posted: April 15, 2010, 12:55 pm
by slickmainer
I found this site while searching for valve covers. looks pretty sweet.
http://www.hawesengineering.com/pages/products.html
Also looks like he is working on some finned ones in the projects section.
Posted: April 16, 2010, 9:31 am
by Bigfoot21075
Looks cool but no prices?
Posted: April 16, 2010, 11:50 am
by Casey 65
The covers are machined from solid to resemble a cast Offy component. They have a recessed pocket on the back to accept the stock gasket and utilize the stock rubber grommet/ washers and hardware for fastening.
The Lifter Covers are priced at $185 each
Matching Fuel Pump Block off plates available for $25 each
Combo Set (Lifter cover plus block-off) $200
A machined matching valve cover (1 in taller) is available for $750. (machined from solid)
Since machining a valve cover isn't cost effective, I'm currently working on a pattern to have a valve cover cast.
Shipping cost = West of Mississippi = $5, East of the Mississippi = $10. Send me and email with the ship to address and I'll give you a total with shipping for outside the continental US.
Posted: April 16, 2010, 12:01 pm
by slickmainer
is that your place Casey? Looks sweet. I'll email you questions
Posted: April 17, 2010, 12:11 am
by MadMaxetc
Looks cool.
I was thinking something more like the X patern like the original.
PS: What software do you use? Looks like solid works.
Posted: April 18, 2010, 1:01 am
by Casey 65
not mine. I contacted him to get prices.