Ignition advive on my Bumpside project.
Posted: March 2, 2007, 8:53 pm
I have a 351W I got from a friend. Recently rebuilt, was warmed up a little, but no real idea on HP or torque. This is going in my 71 F100 shortbed. Will run an AOD and either a 600 or so Edelbrock or Holley vacuum secondary carb.
My problem. I did not get the distributor, and my friend seems to have lost it. So, while that sucks and creates yet another expense, it sort opens up my options.
My goals are easy starting, dependabilty, good performance. I hope to use this truck as my daily driver. As I see it, the options are:
1. Hit the yards and get either a duraspark dist. or something earlier without duraspark and do a pertronix upgrade. I think I'd prefer the non-duraspark route, but not dead set against it.
2. Buy a so-called rebuilt Dist. from NAPA, Autozone, etc. If I do that, probably get a pre-duraspark dist, and convert to Pertronix.
3. Buy a new Vacuum advance distributor from Mallory, Accel, MSD, Pertronix. Would be easiest, but not the cheapest.
Any other options?
My problem. I did not get the distributor, and my friend seems to have lost it. So, while that sucks and creates yet another expense, it sort opens up my options.
My goals are easy starting, dependabilty, good performance. I hope to use this truck as my daily driver. As I see it, the options are:
1. Hit the yards and get either a duraspark dist. or something earlier without duraspark and do a pertronix upgrade. I think I'd prefer the non-duraspark route, but not dead set against it.
2. Buy a so-called rebuilt Dist. from NAPA, Autozone, etc. If I do that, probably get a pre-duraspark dist, and convert to Pertronix.
3. Buy a new Vacuum advance distributor from Mallory, Accel, MSD, Pertronix. Would be easiest, but not the cheapest.
Any other options?