Page 1 of 1
How's this for easy dent removal?
Posted: April 27, 2007, 12:07 pm
by Slick Fan
http://www.metacafe.com/w/501379
I don't think it would work on deep dents, but it sure does on shallow ones.

Posted: April 27, 2007, 1:30 pm
by Greg D
That is pretty cool, using heat/cold to reshrink metal is not a new idea. Interesting and fast twist on an old technique though.
Posted: April 27, 2007, 3:07 pm
by ethan_lanning
would that work on a slick? Or are they made out of to thick of metal for that to work?
Posted: April 27, 2007, 7:37 pm
by Slick Fan
I would think that the thicker the metal, the more shallow the dent it will pop back. I'd like to try it sometime...so far though, I don't have any dents like that. *knock-on-wood*

Posted: April 27, 2007, 8:05 pm
by willy3486
When I was redoing my slick I used a hand torch and heated some places . Then I cool it down with a wet rag. It would take some of the dents out and cause some of the metal to go back into shape. As far as that duster goes heres a trick I did to a ex-girlfriend. I was fed up with the #!#$^% and didn't care what I did to her. She was a pain in the a$$. This was before I worked on computers and I was working on electronics. I had some component freeze-it. It is similar to the air but when iyt is upright it forces out the cold stuff. If you turn it upside down it will freeze the skin instantly. Well the old helfer wanted to know what the freez-it did and I told her. She was in her witchy moods and told me it wouldn't get that cold. She said prove it spray it on my hand. I did, but I turned it upside down. Her skin froze and she yelled out a blood currling yell. It was great to get her back for all the crap she gave me the preveous few days. .
Posted: May 1, 2007, 12:48 pm
by bigtrip460
some of the new stuff you can leave them out in the sun on a hot day and use an ice cube.