Page 1 of 1
This should give an idea of where I'm headed
Posted: June 4, 2007, 6:54 am
by mikecarson
I had to temporarily assemble my CV100 for a move up the street. The cap is on it solely for convenience, it's coming off soon.
[albumimg]2126[/albumimg]
Posted: June 4, 2007, 10:04 am
by jakdad
The cap looks like it fits the later model Fords. Nice looking cap.
Posted: June 4, 2007, 11:03 am
by Slick Fan
Looks like a jigsaw puzzle.
Posted: June 4, 2007, 5:34 pm
by Gator
what suspension mods do you have?
Posted: June 4, 2007, 9:27 pm
by castruck_1964
looks good mike to bad it has to come back apart
Posted: June 4, 2007, 10:42 pm
by killercoating
Is that the Crown Vic install... if so I am so wet right now...
Posted: June 5, 2007, 5:55 am
by mikecarson
killercoating wrote:Is that the Crown Vic install... if so I am so wet right now...
Yes, that's on the CV chassis (my CV100)
Posted: June 5, 2007, 9:50 am
by killercoating
It was a royal pain finding a CV front clip with out going broke here is Chi. But if it turns out like that it will be well worth the reward. Some Slam bags on and it'll be all laid out.
Did you use the CV power steering pump?
And what did you have to do to tie in the steering?
Posted: June 5, 2007, 5:25 pm
by mikecarson
I'm using an entire Crown Vic chassis, 1988 cop car. Drivetrain, steering, etc.
I used the CV column, shortened 4 1/2 inches. Built an adapter out of the hub of the car wheel to mount a truck steering wheel. I need to go over to the truck salvage outside of Waco and find 1 universal joint to get it tied together like it needs to be.
Posted: June 6, 2007, 5:21 am
by STOFFER
looking good mike, how soon until it complete and road worthy????
Posted: June 6, 2007, 6:00 am
by mikecarson
I plan on driving it to SS10, so sometime before that.