Page 1 of 1
Mid-70s Torino
Posted: January 27, 2014, 8:45 pm
by slixtyfive
Does anyone here have access to a 1972-1976 Torino? I need a measurement across the roof if you can help!
Thanks
Re: Mid-70s Torino
Posted: January 27, 2014, 10:06 pm
by 36truck
I will be able to measure that for you when I get back to MI. Next week. If someone else can do it sooner that would be good.
Re: Mid-70s Torino
Posted: January 28, 2014, 12:51 pm
by slixtyfive
That would be great - i'm actually needing two dimensions across the roof from side to side:
1. the width at the bottom lip along the sides (top of door)
2. the width at the 'body line' where the roof turns down along the sides.
Thanks much!
Re: Mid-70s Torino
Posted: February 4, 2014, 8:56 pm
by 36truck
Across roof side to side 4'4". I should have had my puter with me when I went to measure as I didn't get your other measurement. What are you trying to do? I can get a friend of mine to measure it for me later as he has some work to do for me.
Re: Mid-70s Torino
Posted: February 6, 2014, 7:16 pm
by slixtyfive
Thanks
Is the 4'-4" at the point where it bends down or at the point where the top of the doors meet up on the sides??
I've been gathering parts for a 'Vintage stock car' that will be comprised of a mustang body on a shortened torino frame. I can order a cage kit from Speedway for a torino(frame and body) which will obviously work with the frame but I'm trying to figure out if that cage will work for the mustang roof. (concern is that the cage 'halo' will be too wide)
Unfortunately, I gutted and scrapped the torino body a couple years back and didn't think to measure the roof before scrapping it......
Re: Mid-70s Torino
Posted: February 7, 2014, 11:33 am
by 36truck
The 4' 4' is the outside at the bend by the windshield. I would think you could cut down the cage if needed. Is the cage a kit? That would make it easy to modify. What year Mustang are you using the 71/73 should not be too far off.
Re: Mid-70s Torino
Posted: February 8, 2014, 8:28 am
by slixtyfive
Thanks for the info - looks like it will be a bit too wide. I had also thought about narrowing it and that would work fine for the halo but chances are the main hoop (vertical behind driver) would also be too wide at the top. Narrowing that would make it not work with the frame.
Oh well, not a big deal to make a custom cage but was hoping to save some time with the pre-bent kit.
Thanks again for the help.