Page 1 of 1
ok tell me somthing
Posted: August 4, 2014, 8:13 am
by therealjoeshmoe
Re: ok tell me somthing
Posted: August 4, 2014, 10:48 am
by LM14
You're probably going to get pretty much the same feedback as the FB page.
In it's day it was a good stick welder. It's so heavy because it has a lot of copper inside it. The copper may be worth more than the welder itself.
If the TIG portion works, get a bottle of Argon and learn to TIG weld. That's it's best use now. Did you get the TIG gun and gas regulator with it?
Stick welding still has it's place. It works on heavy material or dirtier material. It is a bitch to do on thin metal. Get much thinner than 1/8" and your patience will be tried. Great for 1/4 material. Stick welding works better outside or in wind. Fresh rods are your friend and you need to match the rod to the project, both the metal base and welding position. Learn to read welding rod numbers if you seriously plan to use it. You can also get a lot of specialty rods. Cast iron, Super Rod, stainless and about 100 others. It's getting to be a lost art.
I used to weld everything with a stick welder but have only picked one up twice in the last 30 years. MIG ruins you and you won't use a stick unless it's an emergency.
SPark
Re: ok tell me somthing
Posted: August 4, 2014, 1:35 pm
by therealjoeshmoe
so how old do you think this thing is?
Re: ok tell me somthing
Posted: August 4, 2014, 2:10 pm
by ICEMAN6166
this one looks close to the same, a little smaller but says 1980
http://westslope.craigslist.org/tls/4579991415.html
for a c-note if it was closer i might grab it up.
i learned to weld with this type of equipment but like Steve have not used one very much in the last 20 years.
Re: ok tell me somthing
Posted: August 5, 2014, 9:27 pm
by pikupmn
it may be old.... but if you look inside the newer welders, of any type(mig, stick,etc.) you will find Hobart parts
i've got a 110 Hobart mig and i love it for doing body panels, a stick welder IS doable but boy does it suck and it'll piss you off. just my

. Jeff
Re: ok tell me somthing
Posted: August 10, 2014, 12:04 pm
by mercuryv8
I think these big welders are good for the guy welding at home. They use a lot of power... but so what your not welding 10hrs a day at home. Many of them produce a great weld, often better than the hobbyist would ever need. The best advice here is get a tig torch and you can weld mild steal with it. It will be scratch start unless you can get a high frequency box for it.
Nic