Page 1 of 1

292 cu in Y-block V8 heads

Posted: March 12, 2015, 12:20 pm
by mercuryv8
I'm stuck looking for a set of heads for a 292 cu in in a 55 thunderbird. They are a lot harder to find than you would think. The heads we had have a crack, the head shop we sent them to said they are not repairable.

Any Ideas on where I could get a set?

Nic

Re: 292 cu in Y-block V8 heads

Posted: March 12, 2015, 3:10 pm
by charliemccraney
In general, y block heads are easy to find. If you want the exact same head, to keep the car "correct," that could be challenging. Try Y-Blocksforever or the Y-Block groups on facebook, eBay or craigslist for local stuff.

Re: 292 cu in Y-block V8 heads

Posted: March 12, 2015, 6:52 pm
by 64 f100
What heads are you looking for? I have a set of 57 big valve ECG heads , in fact I have a couple of sets. The numbers are on the heads , kind of in an odd spot. All the heads are listed on John Mummerts Yblock site . I have a few other heads and access to others. If, you need the exact heads to make the car right, then that might be a little difficult to come up with, depending on which ones you need. First you have to let us know what the head numbers are that you have. These may not even be the correct ones for that car. Anyway, let me know if you are interested and what heads you have. Just remember, yours were cracked and so may be any you buy. Best to buy and pay for heads from somebody that will guarantee no cracks. I would have to take mine to get checked before I sold these to you. This adds to the cost of the heads, by quite a bit around here. Best to have the heads checked before paying for shipping though. I have 1K tied up in one set of heads I have, because I had to go thru so many heads to find a good set.

Rich

Re: 292 cu in Y-block V8 heads

Posted: March 12, 2015, 7:10 pm
by jamesdfo
Nic: Call me, I may know someone, if he doesn't have, he will have leads.....

Re: 292 cu in Y-block V8 heads

Posted: March 12, 2015, 11:14 pm
by mercuryv8
Thanks for the replies.

I will get the exact casting numbers and do some more research. Its not a numbers car but I will make certain what's heads will work.

James, I will give you a call when I do that.



Nic

Re: 292 cu in Y-block V8 heads

Posted: March 13, 2015, 6:30 am
by bruceandersson
The challenge with the early y-block heads is that they came with cast core plugs in the ends that have to be there to look correct on a 55 or 56 tbird. Everything (most) made 57 and on does not have these core plugs. You'll need heads from 54-56 to look right and probably from '55 to have the right casting numbers.

Re: 292 cu in Y-block V8 heads

Posted: March 13, 2015, 1:48 pm
by mercuryv8
Thanks for all the replies.

We found a set and they are on their way.

Nic