Page 1 of 1

All I wanted was to get something done...

Posted: July 20, 2015, 6:54 am
by bruceandersson
Sunday was one of those days. After finally clearing up the familial commitments, I was able to head out to the workshop with the aim of replacing the floor pans in a non-slick project. Started out fine, fired up the compressor, got my tools in order and started to cut out the old section with a cutoff wheel. Switched to the air chisel to separate a couple of spot welds and that was as far as I got. When my compressor cycled off, instead of the normal short hiss of releasing the head pressure, it just kept on hissing. I had trouble with the pressure switch int he past where is stuck on and burned out the motor so I assumed it must have been that acting up again.

Here's what I learned and thought it might save somebody some trouble in the future.

First I ordered a replacement pressure switch since I had trouble before. Took a while to figure out what I needed since the old switch was supplemented with new part numbers a couple of times over. Then I took the pressure switch apart to make sure the needle valve was functioning correctly. Seemed to be working correctly. Cleaned it up and put it all back together. Problem persists. Back off and more investigation. Ah, there must be something else that prevents the air from the tank form leaking through as the valve is always open when the switch is off due. Back to the computer, I was not sure if there was something built into the pump or an inline check valve hidden somewhere. There is a check valve, happy to not have to tear the head off the pump. Back to the shop, pulled the check valve from the main line from the pump to the tank. A little testing with the old kisser and it was obviously not working. Back in the house to cancel the first order and order the check valve. I then cleaned the old valve and got it to work, but left the new one on order. Back to the shop, put it all together and ta-da have the compressor working again.

The problem was that it was now 4 hours later and too late to jump back into the project. Hopefully I'll be able to get something done this evening after work.

Re: All I wanted was to get something done...

Posted: July 20, 2015, 7:32 pm
by ICEMAN6166
if theres something to give a compressor fits its the air cutoff wheel
glad your up and running again and not airless for a couple weeks like i was last month when my compressor died
now its a 30 gallon air tank and i have a new used compressor

Re: All I wanted was to get something done...

Posted: July 20, 2015, 10:22 pm
by foodstick
I thought you were going to say you have the same type of oil bleed off I have.. a rust hole in the tank ! Never collects water anymore....

Re: All I wanted was to get something done...

Posted: July 21, 2015, 6:28 am
by bruceandersson
My bleed off is the valve at the bottom of the tank that leaks just slightly. I never have to bleed water either.