Page 1 of 1

Need a measurement

Posted: October 5, 2015, 11:25 pm
by jamesdfo
Need a measurement for a fleetside or styleside box, trying to determine how much dunnage it will take to elevate the box during transport so that the floor braces (which it would be resting upon when actually mounted to a chassis) are supporting the weight of the box rather than the lower edges of outer bed panels....

Can anyone tell me what the vertical distance is from the bottom of the support braces that support the bed floor to the bottom of the outer box panels.

Thanks!
James

Re: Need a measurement

Posted: October 6, 2015, 12:39 am
by LM14
Haul it upside down, it's safer. Put down a pad and put it on the rails.

Spark

Re: Need a measurement

Posted: October 6, 2015, 1:43 am
by Alan Mclennan
12" should be plenty, upside down they would be more stable, but you could damage it flipping it over...