Page 1 of 1

Actually putting a bowtie in the garage

Posted: October 23, 2015, 7:20 pm
by LM14
Had a chance to do some trading so I let the '37 sedan go. Always liked a '55 Chevy 2 door sedan a bit more. Didn't want to hack the firewall on the '37 since it was so nice and this guy wants to put a flattie back in it and convert it to hydraulic brakes and dropped axle and drive it. He probably has a better plan than I did to be honest.

Traded for this one this morning. New floor pans from firewall to back of trunk, new rear suspension, all the patch panels welded in on the quarters. Only 3 or 4 little spots to deal with and they are all quarter sized.

Powered by a good sounding (as much as they can for a SBC) 355 with a small blower (Holley blower) and a fresh rebuilt 4 speed behind it with a new Hurst Competition Plus shifter.

He was filling trim holes (it's actually a BelAir) so I will have to open a few of those back up. I am only using the quarter panel trim and window trim so that won't be too bad.

Uni stays on the front burner and this one goes in the old garage area for later or as parts fall into my hands.

Image
Image
Image
Image

Re: Actually putting a bowtie in the garage

Posted: October 23, 2015, 7:58 pm
by foodstick
Is that the TWO LANE BLACKTOP model?

Re: Actually putting a bowtie in the garage

Posted: October 23, 2015, 8:36 pm
by LM14
It could be. It was a 2 door sedan like this one. I won't be that radical, I promise. If you didn't know it, John Falfa's black '55 in American Graffiti is the same car they used in TLB. It also sowed up in Adam 12 and Dragnet episodes as the primer car/bad guy's ride.

SPark

Re: Actually putting a bowtie in the garage

Posted: October 23, 2015, 9:01 pm
by Toyz
Looks good, Steve! Here is a local '55- 1500 whp worth of BBF!
Image

Paul

Re: Actually putting a bowtie in the garage

Posted: October 24, 2015, 9:53 am
by mercuryv8
Cool looking car for sure!