Page 1 of 1

Fun to be a tightwad.....

Posted: November 18, 2015, 3:46 pm
by slick4x4
Rebuilding the rear leafs on my F250 4x4
Ordered the bushings from LMC..... But.....
To frugal to give the $29.95 for each pin (takes 6) !
Found a nice 3/4" shaft & went to work
Got about 20 minutes & .80 cents in each one....

Image

Re: Fun to be a tightwad.....

Posted: November 19, 2015, 11:48 am
by foodstick
Dang, thats my kinda shopping avoidance ! ;)

Pat be careful...you'll end up like my friend Jim.. scratchbuilding working cranes draglines and bulldozers ;)



https://www.youtube.com/user/RVJimD/vid ... =dd&view=0

Re: Fun to be a tightwad.....

Posted: November 22, 2015, 8:06 pm
by ICEMAN6166
nice job Pat

i was too cheap to spend $12 apiece for 6 big hinges for my garage doors so i made them from used angle iron and bolts
leaves me that $75 for something else

Re: Fun to be a tightwad.....

Posted: November 22, 2015, 10:20 pm
by slick4x4
ICEMAN6166 wrote:nice job Pat

i was too cheap to spend $12 apiece for 6 big hinges for my garage doors so i made them from used angle iron and bolts
leaves me that $75 for something else
Exactly....
That $180 I saved will probably go for a floor mat

I don't WANT to spend that much....
But I WANT a stock looking new floormmat
I CANT make a floormmat that looks stock
So it will be one of the expenses that I HAVE to spend the coin on

Re: Fun to be a tightwad.....

Posted: December 7, 2015, 1:08 am
by Truckrat
Nice job brother! Good to see stuff like that. TR