Page 1 of 1

Round Speedo Factory Gaugues?

Posted: December 11, 2015, 10:50 am
by chris401
Pulled this from a plain 66 F100 I6 city truck for $45. Don't know if that's high or not. Are these dealer gauges? If so would they have been in a 65 also?

Image
Image

Re: Round Speedo Factory Gaugues?

Posted: December 11, 2015, 6:36 pm
by SLICKCOLLECTOR
same gauges and same bezel in the custom cab dash insert. I have seen this combination several times in non custom cab (round) speedometer.

jim

Re: Round Speedo Factory Gaugues?

Posted: December 11, 2015, 8:16 pm
by Toyz
They could be found in non-custom Cab '65/'66's as well as the older leaf front trucks. You may want to attempt to go back for the harnesses for the gauges and instrument lamps to simplify things. An extra note of caution; if you have upgraded your charging system, I would be wary of that ammeter, and at least would try to get the factory circuit breaker, and, again, underhood harness if available . You will of course, also need the sender for the oil gauge. If you wish to retain the warning lamp, you will need to tee off the oil port for both the old switch and the new sender, as well as run an additional wire from gauge to sender. You will also need to tee off the IVR output to supply the pulsed power to the oil gauge. Factory harnesses make this much easier, but can be replaced with a little patience.
That should about cover it, other than the old caveat that you can never have too many grounds!
Paul

Re: Round Speedo Factory Gaugues?

Posted: December 11, 2015, 10:52 pm
by chris401
Trucks gone. Part of the wiring harness was cut out already so I left the rest. Would these have been in chrome as well?
Thanks

Re: Round Speedo Factory Gaugues?

Posted: December 12, 2015, 6:40 am
by Toyz
Image
Yep
Paul

Re: Round Speedo Factory Gaugues?

Posted: December 12, 2015, 6:13 pm
by chris401
Was that like mine with oem gauges at one time or did you drill out the holes?

Re: Round Speedo Factory Gaugues?

Posted: December 12, 2015, 6:57 pm
by Toyz
Drilled out the holes for 2 5/8'' gauges. Eyesight not what it used to be, and it wasn't ever great (except when compared with blindness!). It is OEM factory chrome bezel.
Paul

Re: Round Speedo Factory Gaugues?

Posted: December 12, 2015, 8:19 pm
by chris401
Ok, I had a chrome one without the gauges. I have had this one set aside for a few years. Plan on one day having it refurbished and chromed if chrome with gauges was an option. Going to have this old tachometer refurbished also. Found it in a 60's JC Penny catalog for $11.

Image
Image
Image
Image

Re: Round Speedo Factory Gaugues?

Posted: December 13, 2015, 6:32 am
by Toyz
To my knowledge, mine is the original factory chrome, although I removed all traces of the black accent paint when polishing (and prefer it that way).
Paul