Page 1 of 1

1965 F100 Dash power rectifier power to? From?

Posted: December 11, 2015, 4:05 pm
by RRTEC
My truck has a new "painless" harness, it has wires to all the guages but no wires to the rectifier. Therefore my gauges do not work. Am I wrong to assume that I can tap in to any switched 12V and run it to the rectifier to power up my guages?

Thanks for any advice.

Re: 1965 F100 Dash power rectifier power to? From?

Posted: December 11, 2015, 5:52 pm
by unibody madness
a fused, switched, hot wire should do the trick.

Re: 1965 F100 Dash power rectifier power to? From?

Posted: December 11, 2015, 7:54 pm
by Toyz
The rectifier is a pulsed voltage regulator. You will need to run a full battery voltage switched source as you mentioned; and will also need to run a wire from the output of that IVR to each gauge, with the exception of the ammeter. If you have tested the gauge circuits by either a direct ground or introducing full battery voltage, you may have damaged gauges and/or IVR.
Paul

Re: 1965 F100 Dash power rectifier power to? From?

Posted: December 12, 2015, 12:17 am
by RRTEC
I'm really unsure what was done, as the PO worked on the harness. I do know the rectifier was grounded to the chassis when I took the cluster apart. Super rigged and obviously no understanding of the purpose of the rectifier.

Re: 1965 F100 Dash power rectifier power to? From?

Posted: December 14, 2015, 8:36 am
by bruceandersson
You not only need to power the rectifier, but make sure it is providing the power to the gauges. The ground for the rectifier comes from its mount to the speedo.