Page 1 of 1

Repro Radiator Support Quality

Posted: December 25, 2015, 1:16 am
by matt2491
What's the consensus on the reproduction radiator support (C2TZ16138G) that's out there. Any good? Correct sheetmetal thickness? Actually FITS properly?

Those who have used one please chime in!

Re: Repro Radiator Support Quality

Posted: December 25, 2015, 10:58 am
by ICEMAN6166
no idea on the quality of repops but i just redid mine and the factory tin was .047 thick.

Re: Repro Radiator Support Quality

Posted: December 25, 2015, 3:59 pm
by 6166 Junkyard Dog
one thing I noticed is that where the upper grill supports mount at the bottom on original used clips, repo just threads into the tawain metal so how is that going to work < NOT >, I would just drill a hole through the bottom and put not/bolt to hold it in place

Re: Repro Radiator Support Quality

Posted: December 25, 2015, 5:17 pm
by rw66f100
I used one because my original was too far gone for me to fix. My truck is a 66 so i had to do some Mods to make it work. I'm sure the originals were better but sometimes you have to use what you can get.

Re: Repro Radiator Support Quality

Posted: December 28, 2015, 10:10 am
by 62bigwindow
I hope they are better than the repo unibody tailgates. They are as thin as paper.

Re: Repro Radiator Support Quality

Posted: December 28, 2015, 12:16 pm
by unibody madness
For someone close to California, my son has one off a 61 that was bent in an accident on passenger side.
I am pretty sure there is no rust. some of you guys are doing ten times more work fixing them than it would take to straighten this one. not sure what he wants for it... but I do know he is looking for the inner two+ inches of the swb flare fenders if someone has a messed up set sitting on a wall