223 rocker assembly question
Posted: January 26, 2016, 6:56 pm
Curious if the rocker assemblies on Ford 223's can be interchanged.
Here is what came off the engine I am rebuilding. Horribly gummed up, rockers are scarred inside, the tube is pitted, worn. This was a bitch to take apart.

This is the rocker assembly off the engine I pulled from the truck. It has the two bolts to hold the valve cover on. I did not take it apart, but it is in far better condition. The adjustment screws are different too.

It would cost me about $400.00 for a rebuilt one through National Parts Depot.
What say you?
Here is what came off the engine I am rebuilding. Horribly gummed up, rockers are scarred inside, the tube is pitted, worn. This was a bitch to take apart.

This is the rocker assembly off the engine I pulled from the truck. It has the two bolts to hold the valve cover on. I did not take it apart, but it is in far better condition. The adjustment screws are different too.

It would cost me about $400.00 for a rebuilt one through National Parts Depot.
What say you?