Rear end options
Posted: April 4, 2016, 6:43 pm
Alright so after months debating and doing research and reading everyone's write ups and opinions I've decided to get started on the CV front end swap. I've been so wrapped up in getting all the little things I need for the swap and all the while trying to decide what motor I want to put back into it. I'm in no hurry for any of this just want to take my time and do it right. With that being said and having a pile of parts ready to go in. I started to make a plan for the rest of the truck just to have a goal.
That brings me to my delima. When I bought my truck about a month and half ago I was told by the seller a list of things this truck had. Almost all have been incorrect. I should have known when he claimed it had a 351c and after looking at it for 15 seconds I discovered it was a 351/400m and what he thought was a fmx was in fact a c6. Both of these weren't an issue knowing I was going to change it up anyways. But it came time for him to explain as best he could the situation with the rear end. He claimed engine and tranny where from a Torino. That I don't doubt. But he told me he thinks the rear is a limited slip So I finally decided to jack up the rear and give it the "open rear diff" test and sure enough the wheels spin opposite. So after reading past posts from lots of smart guys on this site I have some questions about rear ends
So from what I've collected the 03+ cv rear won't work because it's to wide? The explorer rear housing needs to be shortened like 6 inches? And the 93ish CV rear end width is a hair short from the front but guys make it work by running bigger offset? So many options and I guess it's personal preference. In the end is any of that really worth it? All I really want is posi trac I mean rear disks would be nice and I do plan to lower it to go with the cv front. As of right now I was just planning to convert to posi trac and lower it with an axle flip. Am I making a mistake? Would love to hear from some experienced members thanks guys
That brings me to my delima. When I bought my truck about a month and half ago I was told by the seller a list of things this truck had. Almost all have been incorrect. I should have known when he claimed it had a 351c and after looking at it for 15 seconds I discovered it was a 351/400m and what he thought was a fmx was in fact a c6. Both of these weren't an issue knowing I was going to change it up anyways. But it came time for him to explain as best he could the situation with the rear end. He claimed engine and tranny where from a Torino. That I don't doubt. But he told me he thinks the rear is a limited slip So I finally decided to jack up the rear and give it the "open rear diff" test and sure enough the wheels spin opposite. So after reading past posts from lots of smart guys on this site I have some questions about rear ends
So from what I've collected the 03+ cv rear won't work because it's to wide? The explorer rear housing needs to be shortened like 6 inches? And the 93ish CV rear end width is a hair short from the front but guys make it work by running bigger offset? So many options and I guess it's personal preference. In the end is any of that really worth it? All I really want is posi trac I mean rear disks would be nice and I do plan to lower it to go with the cv front. As of right now I was just planning to convert to posi trac and lower it with an axle flip. Am I making a mistake? Would love to hear from some experienced members thanks guys