Page 1 of 1

glyptal paint

Posted: May 5, 2016, 8:03 am
by shipwrecked
Guys- I was sand blasting the valve cover and oil pan for the 223 and noticed what appears to be glyptal paint inside them.

I don't know much about this paint, other than a quick google on how it is supposed to allow the oil to flow back faster.
$50.00 a brush on qt can. or $50.00 a 12oz aerosol. yikes!

I assume it doesn't matter does it? on the valve cover- it was mostly worn off.

paint the inside of the valve cover and oil pan with it or leave it blasted?

Re: glyptal paint

Posted: May 5, 2016, 2:55 pm
by LM14
Clean metal will drain back just fine. What it was originally used for was sealing porous surfaces like lifter valleys. not much help on sheetmetal parts. I would skip it.

SPark

Re: glyptal paint

Posted: May 6, 2016, 8:14 am
by BarnieTrk
....and if it isn't properly cleaned prior to application, it will start to peel off (like yours is doing) and then chunks/peels will go down and plug up your oil passages and oil pump pickup screen..... not a good thing at all.

I'd highly suggest you simply remove as much as you can, and do NOT re-coat any of the engine interior surfaces.

BarnieTrk

Re: glyptal paint

Posted: May 8, 2016, 7:25 pm
by Truckrat
April, I have seen people paint the valley on V8s with special paint for better oil drainback, but not the interior of the valvecovers.
Once your cover is clean inside I would leave it that way. TR