Page 1 of 1
So I bought a parts truck...
Posted: May 26, 2016, 7:51 am
by orangeRcode
However, now I'm being told that it's too nice to part. Had a buddy offer me an 08 CVPI for a decent price so I though maybe I would attempt the swap. The parts truck is a 65 long bed so I don't believe the wheel base is correct for setting the body on the CV chassis. Am I correct? I believe all the swaps I've seen were short uni's or short beds? My wife is gonna kill me. The engine for my 66 is currently in pieces awaiting a big box from Summit.
Discuss among yourselves...
Re: So I bought a parts truck...
Posted: May 26, 2016, 7:54 am
by shipwrecked
pictures of this parts truck?
always asking for forgiveness is easier then asking permission

Good luck with the wife not murdering you.
Re: So I bought a parts truck...
Posted: May 26, 2016, 8:43 am
by orangeRcode
shipwrecked wrote:pictures of this parts truck?
always asking for forgiveness is easier then asking permission

Good luck with the wife not murdering you.
I posted some on the FB site when I picked it up. It's not perfect but would make a good driver with a CV driveline.
Re: So I bought a parts truck...
Posted: May 26, 2016, 8:45 am
by orangeRcode
I actually have an extra hood with little surface rust on the inside of it. I may bring to SS if anyone is interested in it.
Re: So I bought a parts truck...
Posted: May 26, 2016, 10:54 am
by Mr. Jones
I'm interested in the hood,pm sent
Dan
Re: So I bought a parts truck...
Posted: May 27, 2016, 12:08 pm
by Truckrat
I think you are right on the wheelbase of the CV.
Could still put the front cross member in it and drive it.
Drive train in the CV good? Front would drop down with the CV
cross member in it. Could lower the back some to level it out.
Might make a nice driver. TR