1966 Longbed
Posted: August 27, 2016, 8:49 pm
I'm sure some of you have seen this project in an old thread. I purchased the project about a year and a half back and figure I should start my own thread on it. I will post as I go but I will start with a few photos of how it was found and then how it sits as of today. Hope you enjoy.
Previous owner installed a Camaro front clip. I've installed drop spindles and a disc brake kit. It had its stock 9 inch rear when I got it but since I got an 8.8 rear ended out of a Ford Explorer. Rear end had been narrowed 8 inches and installed Moser axles. I've had the rear end completely redone suspension wise as the setup that was on it I wasn't to crazy about. It also didn't get wnough lift so built a cantilever setup. Also installed inset 20 inch Detroit wheels up front and dished ones out back. I will keep the photos coming as I still have tons to do. All rear and suspension war was done by Ryan at Bear Lake Customs in Apopka, FL
Previous owner installed a Camaro front clip. I've installed drop spindles and a disc brake kit. It had its stock 9 inch rear when I got it but since I got an 8.8 rear ended out of a Ford Explorer. Rear end had been narrowed 8 inches and installed Moser axles. I've had the rear end completely redone suspension wise as the setup that was on it I wasn't to crazy about. It also didn't get wnough lift so built a cantilever setup. Also installed inset 20 inch Detroit wheels up front and dished ones out back. I will keep the photos coming as I still have tons to do. All rear and suspension war was done by Ryan at Bear Lake Customs in Apopka, FL
