Page 1 of 1

Jeez, it's not even noon yet.......

Posted: November 8, 2016, 1:52 pm
by jamesdfo
Jeez, it's not even noon yet............and I'm going to use up my stupid question of the day:)

So, if'n a guy was to want to swap out the manual trans behind a 300 I-6 in a '66 for a C6 Automatic, is there going to be issues with balance when swapping the OE flywheel for a flexplate?

I'm hoping it will be as simple as robbing the flexplate, blockplate, auto trans starter, kickdown linkage, etc from a newer donor and bolting it all up, but that Murphy guy follows me whereever I go :dontknow:

** Currently only contemplating this, still a long ways from pulling the trigger:)

And the (original??) 300 is only an interim engine, I have recently acquired a 1994 351W Roller engine, which will likely end up in the truck at a later date.....

James

Re: Jeez, it's not even noon yet.......

Posted: November 8, 2016, 6:01 pm
by 36truck
As long as you use the flex plate from the same era as the engine your good to go. I don't remember the year Ford changed the balance but it was in the late eighty's.

Re: Jeez, it's not even noon yet.......

Posted: November 8, 2016, 7:25 pm
by LM14
I6 doesn't need a counterweight.

We ran 6 cyl plates behind our internally balanced V8 race engines to operate the starter (clutch was built inside the transmission, check out Brinn trannys for race cars to see what I'm talking about). If we couldn't get our hands on a 6cyl plate, we just removed the weight from a V8 flex plate.

You can get flex plates at your local auto parts store. We gave $39 for Pioneer plates.

SPark