Page 1 of 1
question for the electrical gurus
Posted: December 6, 2016, 1:42 pm
by unibody madness
What is the best way to run a 6v line on my truck for old school horns?
Re: question for the electrical gurus
Posted: December 6, 2016, 2:31 pm
by jkimbrel65
Use a ballast resistor 12v in 6-7v out. Get one for a mid seventies mopar
Mike
Re: question for the electrical gurus
Posted: December 6, 2016, 3:43 pm
by 64 f100
Be sure to test it before installing to make sure your getting the right voltage.
Re: question for the electrical gurus
Posted: December 6, 2016, 4:38 pm
by charliemccraney
Since horns is plural, two 6v horns in series is 12v. I'm far from an electrical guru, though, so I don't know if there is some reason that won't work.
Re: question for the electrical gurus
Posted: December 6, 2016, 5:20 pm
by bird55
6v horns sound great on 12vs. Just don't blast em too long!
Re: question for the electrical gurus
Posted: December 6, 2016, 7:13 pm
by slick4x4
Resistor .....or
Just give full 12
I agree....just don't lay on the button for long times
Re: question for the electrical gurus
Posted: December 7, 2016, 12:36 am
by Michelle
slick4x4 wrote:Resistor .....or
Just give full 12
I agree....just don't lay on the button for long times
You know all about giving it full power all at one time, huh Pat.
Re: question for the electrical gurus
Posted: December 7, 2016, 10:13 am
by slick4x4
Dang it Michelle ... That was going to be our secret
....
Oh ... You mean the shocker machine ?
