Page 1 of 1

Door Seal help

Posted: December 11, 2016, 6:45 pm
by Leeroy
Hi all, been pretty busy the last few months so missing some of the action around her lately.... Thought I'd ask a question about door seals.

I bought a complete cab kit from Tom a few years back and fitted it all, really happy with the quality and fit of everything but I am having some trouble with the door seals. I'm wondering if I installed them incorrectly or if I'm missing something.

The door fits well, top around the vent windows is all perfect, small gap at the bottom rear corner.
But inside I am getting a small gap where the vent window edge of the door contacts the cab. Its the same on both driver and passenger sides.
It wouldn't really bother me very much but Ive been driving the slick a lot the last few months and it REALLY catches the wind noise around the gap. If I pull the door HARD whilst driving the seal closes up a bit more and the wind noise reduces dramatically.

The pic below is with the door completely closed.

Image


Image

Ive just cracked the door slightly here so you can see where the gap is right at the top where the sun is coming through.

Image
Image

This is how I've fitted the seal
Image
Image

Re: Door Seal help

Posted: December 11, 2016, 8:19 pm
by unibody madness
I am guessing the door is twisted, if it fits right everywhere else roll down your window open your wing put a padded two x four between the truck cab and the opposite top of door and gently twisted the wing corner of the door towards the cab.

Re: Door Seal help

Posted: December 11, 2016, 8:33 pm
by tomrooster
I have the same problem on the drivers door, not so much on the passenger side, rain comes in and wind noise , I also have new rubber seals. Tom

Re: Door Seal help

Posted: December 11, 2016, 9:44 pm
by 64 f100
There are several adjustments you can do to the door with the hinges. Sometimes these will work for you and sometimes you have to get creative. It looks to me as if you may have to bend the window frame some to make it fit. Basically the old use a piece of wood and apply force to the upper part which I believe someone else suggested.

Rich

Re: Door Seal help

Posted: December 12, 2016, 6:56 am
by Leeroy
Yes I thought that may be the case, but Im reluctant to bend the door as it fits very well into the cab frame. The window frame is perfect (for a 60's car) The only area I'd say that isn't is the bottom rear of the door where the curve is. Theres probably a 1/8 to MAYBE 1/4 that sits proud. So bending this part of the door I don't believe would assist the gap along the vent part?
Im thinking to seal that gap I'd need to bend the door frame in at least 1/8 maybe more to contact the seal. Which would then leave the door frame not flush with the pillar anymore. :cussing:
I wondered if there was something seal wise like a flat piece of rubber that would attach to the door frame of the cab to take up the gap?

Re: Door Seal help

Posted: December 12, 2016, 7:31 am
by bruceandersson
I'd move the whole front of the door inwards to try and close the gap. My understanding of all ford doors int he 60s was that they were set a little inward from the fender/windshield in order to reduce wind noise. If you want to keep the alignment you have and don't want to bend the door, then you'll have to move the seal inward by placing something behind it. You could get a small piece of edpm roofing. Its about 1/16 thick so two layers would move the rubber out about 1/2 inch. You cold leave the w/s alone and just glue the same onto the body to bring its surface out.