Page 1 of 1

Brake pushrod firewall seal

Posted: January 24, 2017, 2:06 pm
by Leeroy
Anyone had any luck finding a replacement? Mine no longer seems to be there and it's letting in a bit of 'fresh' air from the engine bay I'd rather it wasn't. I thought about a standard grommet with a hole cut out of it (which I'll do if there's nothing else) but when I did this to the mustang the pushrod would eventually just push the seal out with the brake pedal movement.
I see bronco Tom had a bronco replacement but no idea if it works for a slick.

Image

Re: Brake pushrod firewall seal

Posted: January 25, 2017, 6:43 am
by slickstysix
I just cut a piece of rubber in a rectangle to fit under the booster bolts and punched holes for the mounting bolts and pushrod with an empty .45 shell.

Re: Brake pushrod firewall seal

Posted: January 27, 2017, 2:56 am
by Leeroy
Not a bad thought, but I dont have any empty .45 shells! And the stupid gun laws down this way prevent me getting any :cry:

Re: Brake pushrod firewall seal

Posted: January 27, 2017, 11:03 am
by unibody madness
Leeroy, Dennis Carpenter has a boot listed:
http://dennis-carpenter.com/master-cyli ... p/0a-2180/
its what I used on both my masters, brake and clutch

Re: Brake pushrod firewall seal

Posted: January 27, 2017, 3:24 pm
by Leeroy
Thabks, might give that a go