Page 1 of 1

FE 390 governor at WOT!??? Help.

Posted: May 30, 2017, 9:10 pm
by Andy fox
While coming home from the car show today I was getting on the on-ramp in 3rd gear. (4spd) need more speed so I went WOT and it accelerated some then lost power, maintained speed,rpms went up slowly but motor sounded like it was rapping up much faster. It does this in 4th also. Doesn't matter which rpm I decide to go WOT. I can go as fast as I want in any gear under medium acceleration.

I've adjusted carb before and have just changed the oil? Runs great till WOT. Just thinking it's a carb adjustment? But it revs up to 4500rpms just fine. So maybe tranny? But then it's fine when not under WOT.

Re: FE 390 governor at WOT!??? Help.

Posted: May 30, 2017, 10:21 pm
by chris401
Andy fox wrote:While coming home from the car show today I was getting on the on-ramp in 3rd gear. (4spd) need more speed so I went WOT and it accelerated some then lost power, maintained speed,rpms went up slowly but motor sounded like it was rapping up much faster. It does this in 4th also. Doesn't matter which rpm I decide to go WOT. I can go as fast as I want in any gear under medium acceleration.

I've adjusted carb before and have just changed the oil? Runs great till WOT. Just thinking it's a carb adjustment? But it revs up to 4500rpms just fine. So maybe tranny? But then it's fine when not under WOT.
If I understand correctly your engine is revving high but your not gaining speed to match? If so that is a clutch slipping.

Re: FE 390 governor at WOT!??? Help.

Posted: May 30, 2017, 10:29 pm
by Andy fox
Yeah that's a possibility. But it's a new clutch. Also my Rpms aren't jumping high either. The will increase with the motor when the clutch is disengaged.

Re: FE 390 governor at WOT!??? Help.

Posted: May 31, 2017, 6:34 am
by bruceandersson
Check your accelerator pump. You should get a good squirt of gas when you open the throttle.

Re: FE 390 governor at WOT!??? Help.

Posted: May 31, 2017, 6:29 pm
by chris401
Andy fox wrote:Yeah that's a possibility. But it's a new clutch. Also my Rpms aren't jumping high either. The will increase with the motor when the clutch is disengaged.
A rust plugged line or a LMC fuel tank with the restrictive in tank line flare will give just enough fuel to ease into rpms.

Re: FE 390 governor at WOT!??? Help.

Posted: June 3, 2017, 11:27 pm
by Andy fox
Finally got it!!! Secondary float was off!!!