Page 1 of 1

Crossmember at radius arm brackets

Posted: May 22, 2018, 10:00 pm
by 66camperspecial
I think someone decided to play a joke and have the upper bolted and lower riveted,today I replace the rivets with bolts so it can be removed so the 460/C-6 can be removed as one. It went in with the front clip removed and not going to remove it to pull the motor.

Re: Crossmember at radius arm brackets

Posted: May 23, 2018, 8:20 am
by 6166 Junkyard Dog
it's no joke,, What in the heck was Ford thinking of :?: :?: ask Chris few slick stocks back in that garage trying to get the rivots out with several under his truck some of the dentsides have a different cross member to get the trans out without doing that or pulling engine/trans as one unit

Re: Crossmember at radius arm brackets

Posted: May 24, 2018, 12:02 am
by Alan Mclennan
6166 Junkyard Dog wrote:it's no joke,, What in the heck was Ford thinking of :?: :?: ask Chris few slick stocks back in that garage trying to get the rivots out with several under his truck some of the dentsides have a different cross member to get the trans out without doing that or pulling engine/trans as one unit
Remember that well Tom, was at Dave's place during the BBQ

Re: Crossmember at radius arm brackets

Posted: May 26, 2018, 11:24 pm
by Toyz
Those were rivets on Chris's? Coulda sworn they were bridge pilings!
Paul

Re: Crossmember at radius arm brackets

Posted: June 3, 2018, 6:01 pm
by 66camperspecial
I think I had those rivets out in less then a hour,that 460/c-6 came out easy with it out of the way.