Page 1 of 1

63 wiring question

Posted: November 15, 2018, 7:42 pm
by JeffinMooresville
Hey, i am trying to redo the wiring in my 63 using the existing harness. I have spent a lot of time with the shop manual wiring diagram.

I have a yellow/black wire that comes thru firewall in the 8 terminal connector with the rest of the ignition wiring. It runs over to threnstarter solenoid and just hangs. Was not connected to anything. Has a single female pin connector.

Anybody know what this should connect to? Trying to fix some rigs from previous owner and dont want to miss anything obvious.

Image

Re: 63 wiring question

Posted: November 15, 2018, 8:32 pm
by slick4x4
I'm thinking that goes on the solenoid
It gives full 12 volts to the coil when starting the engine
If your engine starts easy , I would be hesitant to attach it
(I might be wrong on this ... hopefully somebody that is
For certain will chime in)

Re: 63 wiring question

Posted: November 16, 2018, 2:48 am
by shipwrecked
Black and yellow... horn I’m sure.

Re: 63 wiring question

Posted: November 16, 2018, 8:10 am
by greentruck
12768On my 63 the horn wire is yellow w/ blue stripe and the I post solenoid wire that slick 4x4 mentioned is brown with a 90 degree female round pin connecter. the 63 diagram shows your yellow/black wire connecting to a breaker that feeds from the battery side of the starter solenoid.My 63 doesn't have this wire or that breaker that the diagram shows.

Re: 63 wiring question

Posted: November 16, 2018, 3:22 pm
by jamesdfo
Not sure it will help, but have a look @ this...


http://www.fordification.info/tech/wiring_63.htm