Page 1 of 1

1965/1966 Grill Guard

Posted: December 16, 2018, 9:59 am
by 04sd
Does anyone have a factory grill guard on a 65 or 66 truck that could get me measurements on bar spacing and the size of the material it's made from?

Re: 1965/1966 Grill Guard

Posted: December 16, 2018, 12:19 pm
by Blackwaterforge
IMG_2639.JPG
IMG_2639.JPG
Hope this helps
IMG_2639.JPG
IMG_2639.JPG
Tried to add photos
Not sure why it is so difficult on this forum

Re: 1965/1966 Grill Guard

Posted: December 16, 2018, 3:12 pm
by 6166 Junkyard Dog
Not sure why it is so difficult on this forum ????????? IT's not difficult just put in your own photo gallery I have 270 in there without any issues, Just be sure the pics are not too big cause it will kick it out

Re: 1965/1966 Grill Guard

Posted: December 16, 2018, 3:52 pm
by Blackwaterforge
Image

Image

Re: 1965/1966 Grill Guard

Posted: December 16, 2018, 7:50 pm
by 04sd
Blackwaterforge wrote:Image

Image
Thanks.

I've got some other pictures but needed the measurements. What is the height of the center area where it drops down?
Do you want to sell yours :)

Re: 1965/1966 Grill Guard

Posted: December 16, 2018, 8:33 pm
by Blackwaterforge
Will get drop down measurements tomorrow.
Purchased from a member here.
They pop up on eBay occasionally.
There are two 1” round braces that go through radiator support to frame.

Re: 1965/1966 Grill Guard

Posted: December 17, 2018, 7:39 pm
by 04sd
Thanks.

Re: 1965/1966 Grill Guard

Posted: December 19, 2018, 8:39 am
by Blackwaterforge
Center drop is 2 5/8

Re: 1965/1966 Grill Guard

Posted: December 19, 2018, 8:20 pm
by 04sd
Blackwaterforge wrote:Center drop is 2 5/8
Thanks again. This will get me headed in the right direction when I build one.