Page 1 of 1
PS conversion
Posted: April 4, 2021, 8:16 pm
by Kid
How much do I need to shorted the steering column to convert to PS
Re: PS conversion
Posted: April 11, 2021, 10:40 am
by 6166 Junkyard Dog
Darrell I left a message but here are the #'s end to end Remember check your old shaft to see how Ford measured it
65/66 Manual Steering 35 5/8''
Bendix Box 34 15/16''
67/70 Manual Steering 35 5/8''
Bendix Box 34 15/16 ''
Ford Power Steering Box 32 7/8'' that is the one you need Kid
71 and up Manual Steering 36 1/8''
Ford Power Steering Box 33 3/8''
04/12/2021 Wanted to add this,, if going use the 71 and up need to cut some off the top of the shaft where there is a snub where a puller would go ++ couple of threads so your horn ring will work on the 65/70 trucks
Re: PS conversion
Posted: September 2, 2021, 9:24 am
by Anthony
hey Tom, I have a 77 column in my 66. if I cut the nub off the end will a 66 steering wheel fit?
also, I have a wheel off of a 74 Econoline camper.. yea, don't ask.. lol and a wheel and horn ring off a 60 F100 will either of these fit my 77 column with little modification? sorry to hi-jack your post Kid