Page 1 of 1

another one bites the dust

Posted: September 26, 2006, 11:11 am
by ICEMAN6166
went to view the cars we will be crushing in town later this week.
not much to bring back for salvage as most is useless junk and they are already stacked. around back, at the bottom of the pile i saw it
a 63 short uni, doorless, hoodless, only the seat and column left inside.moss grew out of the 6 flowerpots that were once cylinders. another car sat sideways atop its roof, half upon it and half upon its younger neighbor, a 64 impala wagon in much the same health.

i myself will be donating a short 63 uni to the crusher, and it will go doorless, hoodless, just a shell of rust on a frame.everything else i have already removed.

:oops:
that makes 2 more
:boohoo:

Posted: September 26, 2006, 1:52 pm
by Comet
Ice, I would love to find a drivers side rear qtr (bed) from behind the wheel well back on a SWB Uni. Is that something that could be cut up?

Posted: September 26, 2006, 3:53 pm
by rog300b
I would for shure like to see some slick parts at the junkyards over here! Most ricers, swedish, german and french cars at our local yard! But luck is that we got friends over in the US that is willing to ship parts to us few that is into these fine trucks 8)

Posted: September 26, 2006, 4:36 pm
by Johnny Canuck
I thought French cars went straight off the assembly line to the Junkyard.

When American Motors was in trouble and they sold Renaults, that sure is the way it worked. To call those cars Junk would have been a compliment. :cry:

Posted: September 26, 2006, 6:30 pm
by rog300b
For the most I dont like french cars. But my grandfather had once a french made Ford, it was a 1954, maybe older Ford Vedette. I had a 60 hp flathead V8 if I remember correct. It was a nice car. Ford later sold that model to SIMCA, and it was known as the SIMCA Vedette. It came then with a big 4 syl motor as standard, but I think you could get the flathead V8 as an option up to the end of the 50s. I also got a friend who is restoring a 1939 Matford, another french made Ford.

Posted: September 26, 2006, 11:29 pm
by Johnny Canuck
I have heard of these French Flatheads, used by the military and stocked for parts there until very recently. Very desirable as a hotrod block. Every rule must have it exception :thumright:

Posted: September 27, 2006, 1:28 pm
by rog300b
You are absolutly right, JC! Fun is that Chrysler corp. took control over SIMCA in 1963, and later founded Chrysler Europe. Is it then "legal" to put a French made Ford Flathead into a Chrysler? :hm:

:wink:

Posted: September 28, 2006, 12:31 pm
by ICEMAN6166
Comet, that part could be easily cut and shipped. i will look and see if the one here is good.

Posted: September 28, 2006, 9:46 pm
by Comet
Cool Ice! Haha...cool Ice, get it! :lol: