Page 1 of 1
Some Ford history- Birth of the Torino
Posted: February 27, 2008, 9:35 pm
by Phil
You guys might like this. Some old ford lore.
I met Bill in Dearborn 3 years ago. Very cool guy.
http://www.torinocobra.com/articles/birth_of_torino.htm
Posted: February 27, 2008, 10:09 pm
by Greg D
Thanks, that was great. 70-71 are my favorite Torino years. The 71 GT grill is still better though. 
Posted: February 28, 2008, 12:01 am
by Johnny Canuck
Super interesting.
I always wanted, from a young age around 9 or 10, to be a Ford designer. As I approached my late teens, and discovered how far away and how much money it would be to even get a shot at it, it became the impossible dream. Then, I read stories like this and Lee Iaccoca's autobiography, and realize I could have spent 10 years or more designing brake pedals, and don't really think I missed much. But, this is a great story of a guy who beat the system, just the once. Kewl, and one of Ford's best looking cars ever to boot.

Posted: February 28, 2008, 12:28 am
by Ford4jack
That was a cool article thanks for posting it.
Be interesting to see what ideas were around when slicks were designed.
Posted: February 28, 2008, 3:34 pm
by Slick Fan
That's pretty cool. Too bad they didn't use his original mockup grille, that looks schweet.

Posted: February 28, 2008, 4:19 pm
by Phil
When I met Bill at the FCA Nats I left my car home and took my wife's Neon. I wasn't sure it was up to the drive. It was a bummer because I would have had the only other 70 Brougham there besides his blue 351 C car.
I would have expected his car to be like a time capsule but it was an unrestored driver that he kept adding stuff to. Stuff he thought were improvements. He added FORD emblems to his hideaway grill, a rear brake lamp, carpeted package tray, blue dots in the tail lamps and lots of wire loom

. He also added a prop rod that he striped with yellow tape for visibility. One item that really blew me away was the door handles. They were one-off prototypes he swiped when the car went to production. Normally destroyed, he grabbed the only set ever made. He designed the standard Torino/Mustang/pinto handle with a "luggage" grip. It was a pleated look vinyl sheath set on the grip bar area in a recessed section so it fit flush. He said he was pissed the bean counters cut it out.
He also thought someone would design the GT/Cobra dash panel with gauges. They never did. All that was done was to add the sweep tach. Police cars got a 140mph speedo but other than that a base falcon had the same idiot light cluster as a Cobra.
Cool guy we BS'd for quite a while
Posted: February 28, 2008, 6:36 pm
by Johnny Canuck
Kewl beans, phil. are these

the door handles you are talking about? I can't envision what you are talking with re: pleated vinyl.. sounds like a chinese hand fan to me.
where did he use a prop rod?
Posted: February 28, 2008, 11:28 pm
by Phil
Prop rod for the hood. Its weird because his car was like new but he used one anyway.
Picture the standard ford car door handles in 1970.
Where you put your 4 fingers around the handle as your thumb pushes the button, that part of the handle had embossed vinyl around the handle like a grip. It was stamped to look like stitched ribbing and was not just wrapped around the handle, the handle got thinner there so the vinyl was flush with the rest of the chrome.
I dunno, he was proud of it and I immediatly noticed it. Cool detail