Page 1 of 1
Transmission Help
Posted: March 3, 2008, 2:55 pm
by 64kust
I have a 302 with an FMX tranny and was wondering if i could put a C4 or C6 in it,,which is possible but would i have to change the drive shaft to do that??
Posted: March 3, 2008, 3:07 pm
by needmoretime
C4 is your best bet. The early C4's 67 vintage have a 24 spline input shaft. All later models have a 26 spline. This won't matter if you get one with the convertor otherwise you will need to count splines if you order a convertor.
Driveshaft is measured center to center of each yoke. The machinest will calculate the length.
Posted: March 3, 2008, 6:32 pm
by cdherman
Doesn't a FMX take a different bell housing?
Bells for 302 are easy to come by. I'd think a new convertor would be in the works as well.
Don't know the answer to the overall lenght question.
Posted: March 6, 2008, 3:08 am
by 64 litl un
The FMX or late Cruiseomatic is a very good transmission and is real close kin to a C6. They are very heavy because most if not all have an iron case. I would consider getting the FMX rebuilt. It will be expensive but maybe not as much as a new transmission and the modifications to make it work.
A C-6 may go right in. If you can find one with the 302 pattern.
Its no big deal getting the drive shaft cut and rewelded for a different length and yoke. A machine shop or spring place can do that for you.
If I were you and I was planning to change from that FMX I would go with an AOD. Why do all that work and not have overdrive. Early AODs had some problems but they were soon corrected.