Page 1 of 1

Wire Ties

Posted: March 20, 2008, 7:33 pm
by Jonas
Can anyone point me in the right direction? I need to find the plastic/rubber pieces used under the hood to hold wires in place. They are black, they are pushed into holes in the inner fenders, cowl, etc. Then they have a wire tie build into them. Hope this make sense.

Thanks

Posted: March 21, 2008, 11:29 am
by needmoretime
I believe Flashback Tom has them. You can also hit a swap meet this spring and find a restoration supply (clips,screws,hardware) They have it all. I take an old one and match it up!

Good luck and enjoy the hunt hunting.gif


Wayne

Are these what you are looking for?

Posted: March 21, 2008, 7:41 pm
by biggus
Are These what you are looking For?
I bought these from http://www.carolina-classics.com/Detail ... ategory=12
Image

Posted: March 21, 2008, 8:09 pm
by needmoretime
They will work but are not as original if it matters. Depends on the project.

Posted: March 21, 2008, 9:11 pm
by 66 POJ
Check Fairlane parts around the same year. I bought some last year and I believe it was from a Fairlane parts supplier. If I run across the paperwork, I'll post.