Slick 60's

Here are a few photos of my progress on the CV IFS (looking at my welds you can see why I wanted a bolt in set up....)



And here was my solution to the Eccentric holes in the Radius arm bushings, they were originally at a 45 degree angle making for some interesting bracket fabrication... a few minutes with a hacksaw and some carefull welding and now they will be straight with the frame.

Coming along nicely Deuce!, wish we had CV`s over here


Alan,

Nice progress Duece!!!!
Doug

Looks good. As an amateur welder myself I can appreciate a bolt in setup. However it's not the look of the welds but the strength that will matter in the end. Plus they'll be covered by the sheet metal and paint so no biggie.

http://a652.ac-images.myspacecdn.com/im ... e97a13.jpg
http://a405.ac-images.myspacecdn.com/im ... 787334.jpg
http://a889.ac-images.myspacecdn.com/im ... 50e430.jpg
http://viewmorepics.myspace.com/index.c ... ID=3451528
there is a couple links to myspace where i have picts of my CV swap if any one wants so see how my swap is going.

fordman125 wrote:http://a652.ac-images.myspacecdn.com/im ... e97a13.jpg
http://a405.ac-images.myspacecdn.com/im ... 787334.jpg
http://a889.ac-images.myspacecdn.com/im ... 50e430.jpg
http://viewmorepics.myspace.com/index.c ... ID=3451528
there is a couple links to myspace where i have picts of my CV swap if any one wants so see how my swap is going.

here ya go.


http://viewmorepics.myspace.com/index.c ... ID=3451528

thanks i tried for a good wile to do that but was not able to