Page 1 of 1
Looking for a tool
Posted: May 27, 2008, 6:11 pm
by 61ford
anyone know of a tool that will let me get into tight corners and grind welds?cant get in there with my grinder only uses up the tip of my discs and accomplishes nothing
Posted: May 27, 2008, 6:14 pm
by Greg D
If you have a compressor try a die grinder. If not you may try a Dremel tool (similar concept but electric) which also has an optional flexible extension kinda like a dentists drill. I have a pretty extensive setup with mine.
http://www.dremel.com/en-us/Tools/Pages ... x?catid=13
Posted: May 27, 2008, 7:03 pm
by shawns fords
I have a straight and a 90 Degree angle grinder. they both have worked into tight places, I also use cutoff wheels, but when I cant I use a set of matco tools carbide tip grinding bits, they will cut through anything and are small and have many assortments of shapes to accomodate anything your going through. I have had that set since 1992 or 93 and still use them today
Posted: May 27, 2008, 10:13 pm
by dropped64
hot knife
Posted: May 28, 2008, 6:40 pm
by 61ford
a hot knife? ive got a die grinder ive been looking for those tips youre talking about but never can find any grinding dics all they do is hit the areas above and below it u can turn it on its tip and get a little but not really
Posted: May 28, 2008, 6:48 pm
by dropped64
an oxy-accetelene torch
Posted: May 28, 2008, 6:48 pm
by dropped64
dont worry im just kidding