Page 1 of 1
Carb Vs. Fuel Injection
Posted: May 29, 2008, 1:09 pm
by clevor347
Okay so my options for my 351w stroker are carb and fuel injection.. (It's gonna be 425 c.i... 4.10" stroker, 6.2" rods, 60 over on pistons..) If I run fuel injection what all do I have to have for computers? I want carb, but my uncle from Vegas told me fuel injection makes more horsepower? Can anybody enlighten me?
Thanks,
Andrew
Posted: May 29, 2008, 3:30 pm
by PFM-64f100
I can't enlighten you but this stie can
http://fordfuelinjection.com/ If you go with FI then the computer keeps the truck tuned and makes adjustments as needed. I will eventually get my 460 converted to FI. Dave (Wolfe) has a FI 302 in his, it started up very nicly after he finally put oil in it (yea ouch pull and replaced parts then oil LMAO). You can tune FI with addtional electronics. Hope this helps.
Posted: May 29, 2008, 4:07 pm
by Jarrod
from the studies that I have read, EFI won't make any more horesepower. It does make the power more usable though. It broadens the torque curve and aids drivability.
Posted: May 29, 2008, 8:13 pm
by blackagatha
it makes much more consistent fuel mixtures and atomization. i wish I had the cash to put on an efi...
Posted: May 30, 2008, 9:32 am
by FORDBOYpete
All fuel Injection Systems are not the Same. It all depends on what you are calling a fuel injection.
If you have a throttlebody with speed density logic like an aftermarket bolt on deal in mind, I will tell you

= save your money & get a good carburetor it will run at least as well & probably even better IMHO.
If you are considering an MAFS/TPI-EFI, like from a lightening for example, by all means go fot it and get a good tunable P-ROM chip while you're at it. Narry a Carb nor "Throttle Body" (CFI) set up will even come close.
This is just my

, but it's based in experience & how it goes for me.
FBp 
Posted: May 30, 2008, 10:04 am
by lefty
Posted: May 30, 2008, 1:29 pm
by Slick Fan
Posted: May 30, 2008, 1:32 pm
by lefty
Posted: May 30, 2008, 5:22 pm
by Greg D
FBP is 100% right, it all depends on the setup you are going to use. Seeings as you have a heavily modified engine I would consider this;
Do you have or know someone who has the knowledge & equipment to fine tune a custom EFI or are you willing to pay for help?
Are you willing to make the investment ($ & time) to learn the EFI so you can do it yourself (some newer setups are much easier though)?
How good are you or are people you know with carbs?
Both setups have their pluses, one main difference is EFI is 90% of the time more efficient though.
Just abit of food for thought.