Page 1 of 1
Three point seat belts
Posted: March 19, 2009, 8:26 pm
by Lowell
Im thinking about ordering the three point seat belts from G.E.M Streetrod products, and wondering if anyone had problems installing them. I have a seat from a Deluxe cab so ther is less space between the door and the seat to work with. Right now i have Lap belts from a brand x vehicle installed by the P. O.
Posted: March 19, 2009, 10:18 pm
by cdherman
I used them. No real problems -- you should have access to a welder to weld a nut on a length of strap metal. You will slip that down behind the inside rear corner stiffeners to anchor the thrid point.
GEM sends so very heavy round plates that you use under the cab floor to prevent pull out there. I was able to use the 65 in floor seatbelt anchors for the inside attachments, but the outer (by the door) I did not like where Ford put them (the tensioners take more space than then orignal lap belts do). So I drilled new holes, as I recall.....
Overall, I am very pleased. Nice and safe. Certainly better than junk-yard makeshift work. They have lots of colors too....
Posted: March 19, 2009, 10:29 pm
by Alex
I installed a set from SeatBelt4Less Sales $168.00(Andover Company,Maryland) They can match your interior or exterior color. I fastened the retractable mechanism to top of Fuel Tank. Make sure your length is longer then 120 inches if want to fasten somerwhere else. Goodluck.
Posted: March 19, 2009, 10:35 pm
by cdherman
Alex wrote:I fastened the retractable mechanism to top of Fuel Tank..
On first blush that statement sounds a little worrisome. Perhaps you can elaborate and ease my mind. I'd hate to see you in an accident where the impact pulls the tensioner out of the thin metal around the top of the gas tank and not only lets you hit the steering wheel, but thereafter douses you with gasoline.....
I suspect you didn't exactly attach it to the top of the fuel tank......
Posted: March 19, 2009, 10:58 pm
by Alex
Heavily reinforced from the Deck on up. A picture would Have been alot better, but its Dark Here. I had to improvise with the short SeatBelt length.I did know what length to order. Thanks Alex
Posted: March 20, 2009, 8:26 am
by Lowell
Thanks for the replies, everyone, Been wanting to make my 65 just a little safer.
Posted: March 20, 2009, 10:51 am
by Phil