thanks too all for input, I found the problem, it was the power valve on bottom of float bowl, someone on the 'other' ford site suggested I check this as he had a similar problem with a cheap carb kit, so I took off carb and put gas into float bowl and it ran right through, I put the old one back on...

can anyone tell me whats going on with my 65 352 with 2100 carb / manual choke? I put in a kit and now it starts up and idles fine but as soon as I try to accelerate it dies . I've adjusted idle screws in and out, checked timing , don't have a clue whats going on! can anyone offer up some things to ...

will a 79 4 X 4 donor work for me as a donor on my 65 2 wheel drive?

I haven't bought the bronco II sending unit yet , that's why I need to know if it will work or what other options I have
joe

I am about to install a early Bronco II gas tank in the rear frame of my 65 F250 and need to know if anyone tell me if the sending unit for this will work with my existing gauge. any info is greatly appreciated
thanks ,
joe :

thanks Dean,
did you put a bronco II tank in your truck? how did you deal with the vent hole? I wouldn't think you would need to vent tank since the cap is vented.
thanks again
jwilly

can anyone tell me if the sending unit from the bronco II will work with my existing fuel gauge (65 f250 )? or can my old sending unit be modified to work with the new bronco tank? one other stupid question , there is a small hole on top of the bronco tank , what's this for ? thanks for any info jwi...

Hi guy's , new to site, I've been looking into moving my tank and this set-up looks good to me. don't like the mustang because of filler through the floor . My question is what did you use for sending unit? is it available through the same vendor?
thanks
jwilly